GTA

All Springer/NP/PCP Air Gun Discussion General => PCP/CO2/HPA Air Gun Gates "The Darkside" => Topic started by: jawzx on April 24, 2018, 09:03:13 PM

Title: 3D Print a Stand for Your "Alpha" molecular sieve filter
Post by: jawzx on April 24, 2018, 09:03:13 PM

Hi Guys, been a while since I was here, and have been away from my airguns for a bit for a number of reasons, but I'm back at it, and I recently acquired a 3D printer... I have a Shoebox F8 to fill my tanks with and have been using the AirTanksForSale.com Alpha molecular sieve filter/dryer; but I was always annoyed at having to tape/strap/mount it to a vertical surface to use it, So I designed a stand for it that can be made with a small consumer-grade 3d-printer at home! Any of you who are into 3d printing probably already know what to do with this link: www dot thingiverse dot com/thing:2877703

If you are interested in the stand but don't have a 3D printer I can either direct you to a printing service (Shapeways says it will cost about $32 to $45 depending on the material) or maybe make one for you if we can agree on a price... The materials are cheap, but it's time consuming to make.

Title: Re: 3D Print a Stand for Your "Alpha" molecular sieve filter
Post by: PeterL on April 24, 2018, 09:41:43 PM

Very nice and innovative. I have the same filter also. They are great.

Peter