GTA

All Springer/NP/PCP Air Gun Discussion General => European/Asian Air Gun Gates => German AirGun Gate => Topic started by: samTN on June 18, 2011, 02:03:43 PM

Title: Anybody in our forum can prfoessionally convert
Post by: samTN on June 18, 2011, 02:03:43 PM

Beeman/HW springers into nitro pistons?  Do you have any recomendations?  Thanks

Title: Re: Anybody in our forum can prfoessionally convert
Post by: Mark 611 on June 18, 2011, 02:28:34 PM

Sam It cannot be done buddy! :P

Title: Re: Anybody in our forum can prfoessionally convert
Post by: samTN on June 18, 2011, 02:43:12 PM

Mark, check out this link. 

http://www.airgunwerks.com/theobengasstrut.html (http://www.airgunwerks.com/theobengasstrut.html)

I believe I will mover forward with it after doing some research and studies.

Title: Re: Anybody in our forum can prfoessionally convert
Post by: Nathan on June 18, 2011, 03:01:20 PM

The Theoben ram does fit the R-1. Don't know about the Crosman ram. May be differences is the design that prevent it from fitting.

Nathan

Title: Re: Anybody in our forum can prfoessionally convert
Post by: Mark 611 on June 18, 2011, 03:33:06 PM

Sam you are right about the Theoben Rams they do fit, the NP's I believe are only made to work on under latching piston, trigger, Groups. :P

Title: Re: Anybody in our forum can prfoessionally convert
Post by: Onebaddj on June 18, 2011, 10:03:31 PM

Im sure somebody with machine work experiance could figure it out.  I converted my b3 to np. Might be expensive though.

Title: Re: Anybody in our forum can prfoessionally convert
Post by: Tpatner412 on June 18, 2011, 11:09:23 PM

I believe that David Slade does them but like it has been said that is only for the R1