GTA

All Springer/NP/PCP Air Gun Discussion General => PCP/CO2/HPA Air Gun Gates "The Darkside" => Topic started by: Airgunhunter73 on December 11, 2017, 01:07:39 PM

Title: Question: HOW MUCH TROUBLE TO FIT A QB in a Discovery Stock
Post by: Airgunhunter73 on December 11, 2017, 01:07:39 PM

Hey guys and gals I'm looking to put my Badger in a Discovery Barracuda stock and I was wondering how close they are fit as to how much inletting I'll have to do to the stock, I really like the Barracuda style stock from Boyds as I have one of these on my Ruger 1022 really lite and love the looks, I've searched around but couldn't find anything specifically on this fit.

Thanks in advance Terry

Title: Re: Question: HOW MUCH TROUBLE TO FIT A QB in a Discovery Stock
Post by: c_m_shooter on December 12, 2017, 12:29:50 PM

the inletting will be too wide and leave a gap on both sides of the trigger group.  the action screw is further forward on the QB.  I've put a discovery in a QB stock, so going the other way would work too. It will not be show quality though without a lot of work.

Title: Re: Question: HOW MUCH TROUBLE TO FIT A QB in a Discovery Stock
Post by: Airgunhunter73 on December 12, 2017, 01:31:32 PM

Thanks for the reply and info trying to figure out what stock configuration to use I really like the Barracuda and the Evolution style stocks.

Title: Re: Question: HOW MUCH TROUBLE TO FIT A QB in a Discovery Stock
Post by: DLP on December 12, 2017, 08:42:02 PM

I think I read not too long ago about using a Boyd’s Microstock for the Badger. I have a piece of Black Walnut from a tree we cut down. It’s been drying in the barn for almost 30 years. I made a stock for my .17 mach2 and for my Howa .223 from this same tree. It will be my winter project.

Title: Re: Question: HOW MUCH TROUBLE TO FIT A QB in a Discovery Stock
Post by: DLP on December 12, 2017, 08:43:43 PM

Mistake. Microfit not microstock.