GTA
All Springer/NP/PCP Air Gun Discussion General => PCP/CO2/HPA Air Gun Gates "The Darkside" => Big Bore AirGun Gate => Topic started by: badgerfarm on December 07, 2017, 10:08:18 PM
-
Does anyone have a list of O ring sizes for a Career Ultra 9mm?
-
managed to find the illusive list of O rings.
-
Got a link? Share the info?
-
I'll share the info as soon as I get it torn down and confirm the sizes just to be sure. It's amazing how difficult it is to find certain information but Will Piatt was instrumental in providing the information. He has my vote for full tunes and rebuilds and is a really nice guy to boot.
-
The first place to check for leaks would be the pressure gauge o-ring that seals the sliding part of the gauge, very easy to get to also. So, as you can guess, that was the last o-ring that I replaced and did the deed. Also, Will did his magic on my Ultra. Regards, Tom
-
Hi Tom,
That's where it started and I got it resealed and then it was the seals at the front of the air tubes. So I ordered a set of wrenches from Zach and Orings from the Oring store but I'm not sure what the total oring breakdown is until I get it fully stripped. I've got 3 Ultras and I knew that sooner or later they were going to need some attention.