GTA

Support Equipment For PCP/HPA/CO2 and springers ,rams => Optics, Range estimation & related subjects => Topic started by: Mikeyblue on August 20, 2017, 09:20:34 PM

Title: Cp 4x16 40 remove turret ?
Post by: Mikeyblue on August 20, 2017, 09:20:34 PM

I'm a complete newb to air guns. Have a new to me marauder .25 with th center point scope. Going to zero at 27 yards. How do I remove the turret to read back to zero once done? Side screws in thread or the funny ones on top?

Title: Re: Cp 4x16 40 remove turret ?
Post by: BenjiHunter on August 20, 2017, 09:25:30 PM

On some scopes you can't reset the turrets.
I don't know about the center point scope, but I bet others will chime in.

Title: Re: Cp 4x16 40 remove turret ?
Post by: Roadworthy on August 21, 2017, 12:16:08 AM

Check the manual.  It will tell how to do it, and if you can do it.

Title: Re: Cp 4x16 40 remove turret ?
Post by: nervoustrigger on August 21, 2017, 12:25:03 AM

On that style, try loosening the slotted screws on the dial.

Title: Re: Cp 4x16 40 remove turret ?
Post by: sscoyote on September 13, 2017, 01:20:03 AM

Got one of those, get a set of screwdrivers for glasses, and loosen the top screw in your pic above. There may be another on the opposite side too. Can't remember