GTA

All Springer/NP/PCP Air Gun Discussion General => PCP/CO2/HPA Air Gun Gates "The Darkside" => Topic started by: rsterne on May 28, 2017, 10:57:30 PM

Title: Smaller NOE Sizing Bushings Now Available
Post by: rsterne on May 28, 2017, 10:57:30 PM

At my request, NOE have run sizing dies 0.001" smaller than previously available for airgun barrels.... You can now get bushings in 0.215", 0.248", and 0.298" in addition to the larger sizes previously available.... The 0.248" are listed in the .243 cal section, the others in the .22 and .30 cal airgun sections....

http://noebulletmolds.com/NV/index.php?cPath=104&osCsid=t437jgnsq2l9obvjlb8g1efpi6 (http://noebulletmolds.com/NV/index.php?cPath=104&osCsid=t437jgnsq2l9obvjlb8g1efpi6)

I also asked Al to make sizing bushings in 0.241", 0.242", 0.336", 0.337", 0.354", 0.400", 0.450", 0.451" & 0.457".... some airgunners are finding that they are better off for accuracy (and velocity) sizing just under the groove diameter, rather than just over.... NOE listened....  8)

Bob

Title: Re: Smaller NOE Sizing Bushings Now Available
Post by: aceflier on May 28, 2017, 11:01:55 PM

Need .455 and .456  ;) Nevermind see them in the other .45 cal list. Do I need a push rod or will my lee rod work?

Title: Re: Smaller NOE Sizing Bushings Now Available
Post by: rsterne on May 28, 2017, 11:03:08 PM

They are available in the .45 cal section....  http://noebulletmolds.com/NV/index.php?cPath=104_407 (http://noebulletmolds.com/NV/index.php?cPath=104_407)

The Lee rods work fine, provided they are small enough to pass through the bushing without touching it....

Bob

Title: Re: Smaller NOE Sizing Bushings Now Available
Post by: aceflier on May 29, 2017, 12:26:50 AM

Sweet thanks for the heads up Bob.