GTA

All Springer/NP/PCP Air Gun Discussion General => PCP/CO2/HPA Air Gun Gates "The Darkside" => Topic started by: wolverine on May 28, 2017, 10:33:51 AM

Title: Regulating a PCP
Post by: wolverine on May 28, 2017, 10:33:51 AM

I would like to install/have installed a regulator in my Brocock Concept standard.

Choices are limited to a Lane or Altaros.

I have a 6 shot string from A.O.A. when they tested the rifle before shipping and it's calculating just over 25fpe. 

Is 6 shots enough to accurately determine the FPE to request how the regulator is set upon ordering it?

Title: Re: Regulating a PCP
Post by: Smoketown on May 28, 2017, 04:20:03 PM

Robert Lane will give you all kinds of information ...    ;)

http://airgunregulators.com/ (http://airgunregulators.com/)

Cheers,
Smoketown

Title: Re: Regulating a PCP
Post by: triggertreat on May 28, 2017, 05:23:20 PM

You really need to know where the psi falls within the plateau of the bell curve.  Having 6 FPE shots won't give you that.  Having the regulator preset around 1700 psi would be a good starting point, but typically you can figure on having to adjust the regulator once or twice to fine tune once you have it installed.

Title: Re: Regulating a PCP
Post by: ackuric on May 28, 2017, 07:10:11 PM

+1 On Robert Lane...contact him. Regulating isn't just set it and forget it though...you need to do proper modifications which Robert Lane is very descriptive about in his tuning guide. GL :)