GTA
Target Shooting Matches, Discussion & Events => The Long Range Club => Topic started by: d.lead.slinger on April 14, 2017, 10:27:43 AM
-
The wind finally let up enough to give it a shot.
The target printed out smaller than expected (Glad to see I am not the only one :D).
For some reason, the pellets didn't cut clean holes so it was a little hard to measure. I may try and dampen the paper with water next time to see if that helps.
-
Kinda hard to see your reading on the caliper. Probably my computer screen.
Is that 1.960? Or 1.560?
What pellet were you using?
Good shooting either way!
-
Kinda hard to see your reading on the caliper. Probably my computer screen.
Is that 1.960? Or 1.560?
What pellet were you using?
Good shooting either way!
Thanks,
Its 1.56 Its not your computer, i have to shrink the pictures to post. I could read the original pretty good and never thought about what it would look like after.
I am using 18.1 JSBs.
-
Way to go!
Have you posted it for score in the informal 100 yard match?
Blue
-
Good shooting David.
Question.... are you measuring your group from the center of the bull to the furthest pellet from the center as shown in the pic? Or did you measure CTC to the two pellet holes that are the furthest apart?
Either way it looks like you qualify for Sharpshooter. I'll get you upgraded on the list.
-
Measurment was taken center to center but the picture was too blury once i shrunk it. The image posted was from center to show that the 4 ring was smaller than 4 inches.
-
Way to go!
Have you posted it for score in the informal 100 yard match?
Blue
I have not. I think i can do better so if the wind cooperates, i will shoot another!