GTA

Airguns by Make and Model => Diana Airguns => Topic started by: cosmic on April 07, 2017, 02:10:47 PM

Title: how do I remove the trigger blade on a Diana air king t05
Post by: cosmic on April 07, 2017, 02:10:47 PM
Wanting to do a 2 screw mod...
Title: Re: how do I remove the trigger blade on a Diana air king t05
Post by: Roadworthy on April 07, 2017, 05:30:14 PM
Removal of the trigger blade requires removal of the stock (three screws).  Look at the trigger pack.  There are four pins holding the works in.  Pull the trigger a time or two (gun not cocked) to note its motion.  The pin to remove is the pivot pin.  Note that as the trigger blade moves back it also moves up.

The trigger pivot pin is approximately on inch forward of the trigger and perhaps an inch and a half above the bottom of the trigger.  It is probably the lowest and furthest forward of all the pins.

Remove the pivot pin and the trigger blade may be carefully removed.  Note the location of the trigger return spring right above the blade itself.  It's a pretty mild spring and easy to put back into place.

Read the second screw mod info carefully.  You must remove a pin which is currently acting as the first stage then drill and tap a hole to allow a new screw to be added to push first stage of the sear.
Title: Re: how do I remove the trigger blade on a Diana air king t05
Post by: Dockey 454 on April 07, 2017, 06:09:42 PM
  Here are a couple of pics of a 48, To5 I did. Pay close attention at what angle you come thru the trigger at. I used a screw from a factory TX 200. Made the trigger very nice, and adjustable.
    Tom
   
Title: Re: how do I remove the trigger blade on a Diana air king t05
Post by: cosmic on April 08, 2017, 03:03:33 PM
Thanks all ! I gave Mike a call at Flying Dragons and he thinks he has a metal 2 screw.. He is in the process of finishing his new shop and has a pallet of parts to look through !! He also said I could send mine to him and he would do it for me !! Nice guy to talk to !!