GTA

All Springer/NP/PCP Air Gun Discussion General => PCP/CO2/HPA Air Gun Gates "The Darkside" => Topic started by: josixpack on March 27, 2017, 02:10:30 PM

Title: Air Venturi 13cu Tank Stock Mod
Post by: josixpack on March 27, 2017, 02:10:30 PM

I purchased the Air Venturi 13cu tank, adapter and stock for the Sig Sauer MCX.  However, this setup is to long for me. 

I started thinking while looking at things and thought if there was only a way to move the stock forward it may just work.  So, I grabbed my 2 inch hole saw and cut the back out of the stock.  Voila, I now have an adjustable stock for my tank!  It fits snug enough that it does not move around when shouldered. 

Getting the pressure gauge in the right position so it is not sticking in your cheek is a bit tricky but after a couple tries I got it.  For me it needs to be on top or on the left side.

Just thought I would share.

Title: Re: Air Venturi 13cu Tank Stock Mod
Post by: M4cr0s on March 27, 2017, 05:28:34 PM

Sillty question, but does this mean you'll run it off CO2 or compressed air now?

Mac

Title: Re: Air Venturi 13cu Tank Stock Mod
Post by: josixpack on March 28, 2017, 01:05:53 PM

Quote from: M4cr0s on March 27, 2017, 05:28:34 PM

Sillty question, but does this mean you'll run it off CO2 or compressed air now?

Mac

I can run it either way. 

I have a scuba tank to fill my PCP guns and the AV 13cu tank or I can use 88-gram or 90-gram CO2 tanks. 

The nice thing about the AV 13cu tank is it can be removed with minimal air loss where the co2 tanks can not be removed with out exhausting all the air.