GTA
Airguns by Make and Model => Evanix Airguns => Topic started by: Rollo on February 28, 2017, 11:44:21 AM
-
Ok, so I've found the adjustment screws on the trigger but do I need to bleed all the air out of the reservoir to take the trigger guard off??? And does anybody have a assembly diagram for this thing??? According to the manual that came with it some of the operation features is the same for the Blizzard S10. I have read about the polishing of certain sear surfaces makes this a better trigger but I'll wait until I tackle that one. I just want something that is sub 5 lbs. Right now it feels like 10 lb. Any advice would be greatly appreciated.
-
Take off the grip and take off the front trigger guard screw and you'll get it off. Check my my .357 RS2/Blizzard tuning thread for what needs to be done to the trigger sear. You may also have to shorten the blade a bit, it locked to the guard in my .45 X2.
Edit, there might be a rear screw for trigger guard as well but you'll figure it out once the grip is off.
-
Take off the grip and take off the front trigger guard screw and you'll get it off. Check my my .357 RS2/Blizzard tuning thread for what needs to be done to the trigger sear. You may also have to shorten the blade a bit, it locked to the guard in my .45 X2.
Edit, there might be a rear screw for trigger guard as well but you'll figure it out once the grip is off.
Thanks for the info. Yeah, was very easy. MUCH better now. I see how some polishing could make improvement but I'm not going there yet. I still need to figure out that this one likes. Getting sporadic groups right now. it groups, but just in 3 or 4's. Thanks again for the trigger info! Great thread BTW...