GTA

All Springer/NP/PCP Air Gun Discussion General => PCP/CO2/HPA Air Gun Gates "The Darkside" => Topic started by: Tucobenedicto on February 20, 2017, 07:11:48 AM

Title: Prod trigger work
Post by: Tucobenedicto on February 20, 2017, 07:11:48 AM

Just polished the sear surfaces of the internal parts (not hammer sear),lubed with moly grease and adjusted for single stage unscrewing the second stage screw all way out and adjusted the first stage for zero pre-travel and a little falling sear disengagement.
Now the trigger is very light (but still safe) and i can feel a smooth short trigger travel before shoot release.
I think this can improve my groups,will test soon.