GTA

All Springer/NP/PCP Air Gun Discussion General => PCP/CO2/HPA Air Gun Gates "The Darkside" => Topic started by: birdmove on September 09, 2016, 05:23:36 PM

Title: Question on seal for CO2 cartridge on 2400KT
Post by: birdmove on September 09, 2016, 05:23:36 PM

  Well, yesterday, when removing the CO2 12 gram cartridge from my Custom Shop 2400KT, the seal came out too. Went to Crosman web site, and couldn't find a 2400KT listed. Did find the 2240 parts list. I wonder if it uses the same seal? Looks like it might be a 130-035 o'ring?   I assume I have to remove the barrel, remove the, what they call the powerlet tube, from the grip frame? Or can I leave the grip and barrel on and get the valve out that contains this seal/o'ring?

    I haven't done much work on these, but have replaced the plastic breeches with steel ones on a 1377, 1322, and my 2400. Is it a waste of time trying to come up with a suitable o'ring from a hardware store? or should I order it from Crosman?

    Thanks for any toips and comments.

Title: Re: Question on seal for CO2 cartridge on 2400KT
Post by: floydlong on September 09, 2016, 05:54:22 PM

Jon,
The 2400KT and 2250 is the same. Use the same parts. That'll make it easy to order. And don't forget to put a drop of 30 wt. non-detergent oil or Pelgun oil on the cartridge tip before inserting.
Good luck.

Title: Re: Question on seal for CO2 cartridge on 2400KT
Post by: floydlong on September 09, 2016, 06:10:53 PM

Jon, the Crosman part # is 6397-012.
Good luck!

Title: Re: Question on seal for CO2 cartridge on 2400KT
Post by: DRose on September 09, 2016, 07:06:42 PM

G397-12 is the proper part number. Dave (http://G397-12 is the prosper item number. Dave)