GTA
All Springer/NP/PCP Air Gun Discussion General => PCP/CO2/HPA Air Gun Gates "The Darkside" => Topic started by: Dairyboy on September 09, 2016, 10:50:13 AM
-
Just an FYI to any maximus guys wanting an Mrod trigger you will need to mod your stock and open up the area where the trigger goes. Width wise is perfect but on the maximus they changed the trigger opening to fit snugly on the trigger guard rather than a big oval like on the discos. Took only 10 minutes for me but was easy with a dremel.
-
Good information. Just clearance the stock inside for the Mrod trigger.
Just to clarify for newbs, this is the Gen1 Mrod trigger correct? Same assembly as the Challenger trigger part number 1763A105
and also should be shimmed .030 somehow such as with washers or preferably the spacer sold by airgunlab http://www.airgunlab.com/products/Marauder_Trigger_Spacer (http://www.airgunlab.com/products/Marauder_Trigger_Spacer)
-
Correct gen 1 trigger with Airgun labs spacer. Mine came off a rough disco I bought for parts and had norms trigger guard as well. Basically I have 4 discos so I took a disco stock and the maximus stock and flipped them belly up and I dremeled the maximus stocks trigger slot to match the discos. Will take pics and measurements later but it does all fit perfectly.
-
If you are going to upgrade the Maximus trigger you can get the MRod trigger, spacer and trigger guard as a complete assembly right here http://discosrus.net/disco/ (http://discosrus.net/disco/)
Complete set up ready to go.
Norm