GTA

All Springer/NP/PCP Air Gun Discussion General => PCP/CO2/HPA Air Gun Gates "The Darkside" => Topic started by: Underwhelmed on July 02, 2016, 08:14:32 PM

Title: New Huma reg for a week old .25 Synrod
Post by: Underwhelmed on July 02, 2016, 08:14:32 PM

I think I might try and tackle installing the Huma this weekend, but was curious of others who've installed in the .25 specifically, did you install against the gauge block so you can see the regulated pressure, or remove it for a bit more volume?

I'm of two minds on this and just looking for some pros and cons either way from others before I tear into mine.

Thanks in advance.

Title: Re: New Huma reg for a week old .25 Synrod
Post by: Booger on July 03, 2016, 05:56:50 AM

Quote from: Underwhelmed on July 02, 2016, 08:14:32 PM

I think I might try and tackle installing the Huma this weekend, but was curious of others who've installed in the .25 specifically, did you install against the gauge block so you can see the regulated pressure, or remove it for a bit more volume?

I'm of two minds on this and just looking for some pros and cons either way from others before I tear into mine.

Thanks in advance.

I've only installed in the .177 & .22 MROD and really like knowing what the regulator pressure is set at. I installed one in my Hatsan and have no clue what the regulator is set at. :)

Title: Re: New Huma reg for a week old .25 Synrod
Post by: Underwhelmed on July 03, 2016, 10:52:15 AM

Thanks for the feedback Booger. I'll probably end up leaving the gauge block in place just to be able to verify that the regulator is regulating to where it is set.

Title: Re: New Huma reg for a week old .25 Synrod
Post by: wimpanzee on July 03, 2016, 11:01:30 AM

i like having mine show the regulator pressure. as velocity picky as my barrel is, it is nice knowing exactly when I am off reg - at least confirming why those last two shots went astray...

there is a few cheap mods, but require drilling, that will let you have a reservoir gauge and a regulator gauge.