GTA

All Springer/NP/PCP Air Gun Discussion General => PCP/CO2/HPA Air Gun Gates "The Darkside" => Topic started by: bird blaster on March 06, 2016, 08:24:51 PM

Title: Mrod is loud
Post by: bird blaster on March 06, 2016, 08:24:51 PM
For some reason my dad mrod is louder than it was. Still shoots accurate. Any ideas why?
Title: Re: Mrod is loud
Post by: clgraham82 on March 06, 2016, 08:40:15 PM
Is the breech oring still in there?
Title: Re: Mrod is loud
Post by: bird blaster on March 06, 2016, 08:41:42 PM
this is a stupid question but where's the or ing? On my disco I can see it.thanks
Title: Re: Mrod is loud
Post by: clgraham82 on March 06, 2016, 08:46:10 PM
Quote from: Pestbirdkiller on March 06, 2016, 08:41:42 PM
this is a stupid question but where's the or ing? On my disco I can see it.thanks

Pull the bolt back and you should see it sitting inside a groove where the pellet loads.

Check out this post...
http://www.gatewaytoairguns.org/GTA/index.php?topic=39932.0 (http://www.gatewaytoairguns.org/GTA/index.php?topic=39932.0)
Title: Re: Mrod is loud
Post by: bird blaster on March 06, 2016, 09:07:00 PM
I just checked the o ring is gone. I fired it and it scared the living &^^& out of me. It was so loud it rang my ears. Where do you order o rings from? Thanks
Title: Re: Mrod is loud
Post by: clgraham82 on March 06, 2016, 09:29:50 PM
http://www.network54.com/Forum/79537/thread/1302911557/Marauder+.177+and+.22+O-ring+list (http://www.network54.com/Forum/79537/thread/1302911557/Marauder+.177+and+.22+O-ring+list)
Or you can call Crosman

Google is your friend!  ;)
Title: Re: Mrod is loud
Post by: bird blaster on March 06, 2016, 09:49:55 PM
Thanks I was just wondering if there was any bad ones or good ones. Seems like an o ring is an o ring.
Title: Re: Mrod is loud
Post by: npunk42 on March 07, 2016, 11:28:46 AM
They are 009s you can buy at Home Depot or such as. Im sure there are differences in material durability, but in the meantime you can get up and running with anything until you settle on one material, ie: buna, nitrile, viton, etc. You're going to change it out from time to timeanyway, carry a few spares, they're pretty cheap.
Title: Re: Mrod is loud
Post by: Bullfrog on March 07, 2016, 11:30:55 AM
In my experience, the Lowes orings are superior to the Crosman orings. In the plumbing section look for .25 ID orings. .
Title: Re: Mrod is loud
Post by: Dairyboy on March 07, 2016, 11:46:57 AM
Beware though I bought a rebuild kit that came with some and they were harder than the oring that came originally and was very hard to push pellets through and even the bolt wasnt easy to push through. Even was throwing off my accuracy. Stole the one out of my crosman barrel (replacing mine on MMHF barrel) now its back to normal.