GTA

All Springer/NP/PCP Air Gun Discussion General => PCP/CO2/HPA Air Gun Gates "The Darkside" => Korean Gate => Topic started by: msurf on November 20, 2015, 02:22:34 PM

Title: O ring sizes
Post by: msurf on November 20, 2015, 02:22:34 PM
Has anyone made a list of o ring sizes for rebuilding a 909 or Dragon Claw?  I am getting ready to tear down a few rifles and would like to have spares on hand for r & r.  I will compliie a list if not, but I know measuring used rings can get a bit tricky.  Thanks!
Title: Re: O ring sizes
Post by: Rattus58 on February 08, 2016, 12:29:27 AM
Quote from: msurf on November 20, 2015, 02:22:34 PM
Has anyone made a list of o ring sizes for rebuilding a 909 or Dragon Claw?  I am getting ready to tear down a few rifles and would like to have spares on hand for r & r.  I will compliie a list if not, but I know measuring used rings can get a bit tricky.  Thanks!
That's probably a good idea to have that on hand...
Title: Re: O ring sizes
Post by: Nev on February 08, 2016, 01:28:52 AM
Quote from: msurf on November 20, 2015, 02:22:34 PM
Has anyone made a list of o ring sizes for rebuilding a 909 or Dragon Claw?  I am getting ready to tear down a few rifles and would like to have spares on hand for r & r.  I will compliie a list if not, but I know measuring used rings can get a bit tricky.  Thanks!

Also the material they are made of is quite important, I have a Logun S16 which I was advised to always use "Viton" seals !