Had a request for a picture of the new pressure gauge on my Yong Heng compressor so here it is. Was a bit bigger than expected but made it work. It's easier to see from the front than the old gauge.
I ordered this fitting to convert from metric M10-1 to 1/4" NPTAnd I ordered this gauge I had to remove one stainless line and fitting in order to screw the gauge into the block and then re-assemble.
Quote from: tracker1955 on February 22, 2019, 10:54:59 PMI ordered this fitting to convert from metric M10-1 to 1/4" NPTAnd I ordered this gauge I had to remove one stainless line and fitting in order to screw the gauge into the block and then re-assemble.Thanks for the info, but when I looked up the gauge it doesn't give the diameter. I'm thinking that it may be 2.5" since it has a -25 at the end of the part number. Is it indeed 2.5" diameter