GTA
All Springer/NP/PCP Air Gun Discussion General => Vintage Air Gun Gate => Topic started by: murray p on February 22, 2021, 10:13:22 PM
-
Need some help with this one, got new seals in and holds air but the gun will not cock, if anyone can help pls do
tks murray
-
Need some help with this one, got new seals in and holds air but the gun will not cock, if anyone can help pls do
tks murray
I've been inside one....a real odd duck.
I remember a part being broken, but not much else....
Good luck!
-
Need some help with this one, got new seals in and holds air but the gun will not cock, if anyone can help pls do
tks murray
I've been inside one....a real odd duck.
I remember a part being broken, but not much else....
Good luck!
Can you tell me how to disassemble a 125 Rawhide. I'm not willing to tear into something unless I can study a schematic before hand and Crosman apparently never produced one.
Thanks - John
-
No pics anywhere but not hard, 2 screws take stock off pull cocking arm straight out and a screw at back of action take out and cover comes off, then a screw on top at back will seperate tube, then set screw for barrel comes out or just loose. The front barrel clamp comes off then a pin needs to be driven out near action and a screw near action, when clamp comes off barrel the bb feed spring and bits all just slide out and then just lifts up from receiver, the compression tube then pulls off pump arm and pump arm I never took completly out, hope that helps
-
Forgot to mention pump tube has knurling on end and is pressed into receiver so you have to put a rod or screwdriver in linkage hole and then tap it to get tube out
-
Murray, thanks for the help, I appreciate it.
John