1
PCP/CO2/HPA Air Gun Gates "The Darkside" / Re: .25 Avenger revisit.« Last post by avator on Today at 07:25:31 AM »I should probably begin the day by casting some .25 RF pellets I think I only have 50 or 60 of them.
2
Back Room / Re: So if you didn't do anything airgun related what did you do today?« Last post by Back_Roads on Today at 07:23:30 AM »Set out to cross Cook Strait today in my yacht. Not a nice place to be today. Very big cresting waves so now hiding behind Mana Island and will see what it is like out there tomorrow. Just put the billy on. Tea anyone?It has been windy, even whitecaps on puddles around here. 3
Back Room / Re: So if you didn't do anything airgun related what did you do today?« Last post by Novagun on Today at 04:35:25 AM »Set out to cross Cook Strait today in my yacht. Not a nice place to be today. Very big cresting waves so now hiding behind Mana Island and will see what it is like out there tomorrow. Just put the billy on. Tea anyone?
4
PCP/CO2/HPA Air Gun Gates "The Darkside" / Re: Introduction to PCP airguns - an article« Last post by nervoustrigger on Today at 03:47:42 AM »The document is in PDF format which is widely regarded as the longstanding gold standard for WYSIWYG (what-you-see-is-what-you-get) viewing and printing. Very likely it will print correctly without having to configure any special settings whatsoever but in the unlikely event it doesn't, open it in FoxIt or Acrobat and bring up the print dialog and select "Fit to printer margins".
5
Hunting Gate / Re: Me vs. My Cat« Last post by airgunaut on Today at 01:06:58 AM »The successful surgery must be a big relief. I’d be so anxious. And I know my time will come to get both eyes done also.
Enjoy bionic stereoscopic vision! 6
Crosman-Benjamin Air Gun Gate / Re: Extended Pump 1322« Last post by ray1377 on Today at 12:41:46 AM »Well, I did get the 600fps at 8 pumps, which is what I was aiming for, simply by changing the Buna O rings on the pump piston to better sealing 70 durometer cast polyurethane. The average at 8 pumps was 604fps with the 14.3g pellets. Just for fun I tried that action in a walnut stock that I had from another similar 2200 project. Going to shoot it like this for a while and work later on the retained air above 12 pumps and add about 1 inch or so longer barrel for a TKO. I also think you can cut the front tube shorter for better balance on the pistol stock and still keep the same compression stroke. It only takes a few minutes to swap the rifle/pistol versions back and forth. Got too much home and yard work to play with air guns for a while.Van that carbine looks great! If you shorten it be sure and take lots of pics during the process Ray 7
Back Room / Re: So if you didn't do anything airgun related what did you do today?« Last post by Novagun on April 18, 2024, 11:49:53 PM »Set out to cross Cook Strait this afternoon in my small yacht. Too rough. Big cresting waves so turned back and now anchored inside Mana Island to see what tomorrow brings. Just going to put the billy on. Tea anyone?
8
Air Gun Gate / Re: What airgun related did you do today?« Last post by Frank in Fairfield on April 18, 2024, 11:07:04 PM »Adjusted first stage on the new TX
9
Back Room / Re: So....Whatcha Eating?« Last post by fireslinger on April 18, 2024, 11:05:49 PM »Try a fruit salsa like pineapple or mango. The sweet and spice goes well with the salty savory of the fish
10
Back Room / Re: So....Whatcha Eating?« Last post by Xraycer on April 18, 2024, 10:35:11 PM »Asian-Mexican, huh? Sounds interesting!Normally I dont eat bass but the they wanted the little dinkers out of the lake so I kept most of the eatin size bass I caught todayThat's a good day of bass fishing, Chris! |