So went and mounted the new Centerpoint 4x32 scope I convinced Crosman to send me. With 10 pieces of tape shimming the rear mount and windage and elevation on the scope maxed out my groups are 12" low and 16" to the right. I'm shooting from about 12 yards. At the same time, I can pretty much hit where I'm aiming at when using the iron sights. (although the windage is maxed out). I've tried 2 different scopes and cant figure out whats going on here...I'm about to start bending the barrel, but I just wanted to make sure I'm not shooting to close, or hey!....I got this rifle to take some stress of after a recent injury (been in a wheelchair since March) and its just ^*%$#@ me off more
...Centerpoint 4x32 scope I convinced Crosman to send me...I'm shooting from about 12 yards...
It sounds like you could have a bent barrel. You could attempt to straighten it. Same procedure as bending it.
Quote from: Scotchmo on August 30, 2012, 04:23:22 PMIt sounds like you could have a bent barrel. You could attempt to straighten it. Same procedure as bending it.That makes good sense Only one question, what are you using for a straight edge to align the barrel.A string run through one or both of the 11mm dovetail rail groves would ideally reference the barrel alignment to the dovetail rail.Sam
Quote from: Scotchmo on August 30, 2012, 04:23:22 PMIt sounds like you could have a bent barrel. You could attempt to straighten it. Same procedure as bending it.That makes good sense Only one question, what are you using for a straight edge to align the barrel....