I am to the point where I am trying to remove the probe latch. It just does not want to come out. I have removed the set screw underneath, the narrow pin the latch pivots on and the probe latch spring. It appears that it it should just slide out underneath the probe once the probe is in the latched position. But it just doesn't seem to quite come out. Any suggestions?
Hey guys I'm new here. I registered because I found this thread while googling how to disassemble my Dynamax. I can't figure out how to remove the hammer. I got the hammer spring out but that's as far as I got. Also I'd like to get the valve housing out. The fitting where the air tube screws on. Any help would be appreciated.
Loosen the set screw at the rear of the hammer and then pull out the hammer latch pin.
Quote from: Peanutjohn95 on April 02, 2018, 02:41:47 PMLoosen the set screw at the rear of the hammer and then pull out the hammer latch pin.How does the spring tophat come out? It doesn't fit through where the hammer spring set screw goes..