Not sure where you bought yours from, but you cannot screw the reservoir directly into your scuba tank. You will need a fill adapter for the tank, which will include a gauge, feed tube and an adapter for the guns reservoir which should have been offered to you by the dealer. I purchased mine from airtanksforsale.com, but others are available from Pyramid Air and others. Good Luck with your CZ, you are going to love it!pv
Eldor,Nice purchase! If you don't mind me asking, where did you buy the rifle from?Thanks,Taso
http://www.champchoice.com/store/main.aspx?p=ItemDetailOptions&item=S210The link above shows the fill adapter you can get for the CZ tubes. The CZ tubes typically have a gauge on the front, hence the need to unscrew them from the gun for filling. The adapter above, if I understand it correctly, can screw directly into your scuba tank DIN valve, then the tube screws into the other side. There is a vent screw to bleed the air once you fill up.PA also sells a similar fitting.Depending on who you purchase the gun from, will determine what is included.Hope that helps.
https://www.pyramydair.com/product/air-arms-t200-sporter-air-rifle-target-sights?m=2622Read through the description on the link. It should help explain the procedure."DIN adapter included (remove tank from gun, attach DIN adapter to fill source and screw tank into DIN adapter)"
I just sold an Air Arms s200 that is very similar to the CZ200. CZ barrels are know to be tack drivers so I am sure once you find the right pellet(s) you will be very happy. Huma makes a regulator that screws right on so before buying any upgrades like the manometer(psi gauge) do some research. Nick at Huma is a good guy that knows a lot about AA airguns so I would start with him even if you do not buy from Nick he will help you out. Another upgrade I found most useful is the TKO muzzle(LDC)it made the s200 practically silent and install is turning a set screw. $80 shipped if I remember right at TKO.com. Last the 10 shot adapter and magazine transformed the s200 from a single shot to a repeater. Easy install that you can take on and off in a couple of minutes once you get the hang of it. AGD had the best price for a complete setup.Good luck with your CZ200. Its almost guaranteed you bought a shooter. Photo of an s200 with the magazine and TKO installed.
Eldor,Thanks for the information. I've been wanting an Air Arms T200 for a while. Pyramid Air does have them but I've been looking to see if there are better or cheaper alternatives. So far, I have not found any. I want a S400 MPR but I have a beer budget lolI checked the AirgunsPlus site to see if there was an advantage with the exchange rate but the Air Arms at Pyramid Air is still cheaper.Thanks,Taso
Isn't the T200 made by CZ and then branded as Air Arms?
Just as an FYI, I bought Sam's gun and am loving it.The Air Arms tanks do NOT have a gauge due to the T-fill adapter. The advantage is not having to take the cylinder off the gun to recharge. But you can buy a combination fill port / gauge so you have the best of both worlds.The CZ tubes have the gauge instead of the fill adapter.Confusing as it is essentially the same gun. Either way they are fantastic guns and very easy to work on. There are many good posts on this site showing how to tune / adjust them to suit your needs.Good luck waiting, it is the worst part.Bruce
Quote from: bruce.net on February 24, 2016, 01:28:54 PMJust as an FYI, I bought Sam's gun and am loving it.The Air Arms tanks do NOT have a gauge due to the T-fill adapter. The advantage is not having to take the cylinder off the gun to recharge. But you can buy a combination fill port / gauge so you have the best of both worlds.The CZ tubes have the gauge instead of the fill adapter.Confusing as it is essentially the same gun. Either way they are fantastic guns and very easy to work on. There are many good posts on this site showing how to tune / adjust them to suit your needs.Good luck waiting, it is the worst part.BruceSam's gun???You really mean the Air Arms version (which I had thought was better in every way) does NOT have a gauge? How then can you tell how full the cylinder is? Wait until it stops shooting or the POI starts dropping? Surely not!If I understand you correctly, the AA version has a quick-fill feature that the CZ version doesn't. And the CZ version has a gauge which the AA doesn't?I'll be looking for those tuning and adjusting posts, because since I have my PAL (Canadian license) I'd like to get AT LEAST as much oomph out of the gun as the US version has. Mine will be less than 500 fps, while the target model in the US is 575. And the full non-target version gets about 800 fps. I don't need 800, but I'd be real happy with around 600.Is your gun the target model? If so, what is the peep sight like? From photos it looks exactly like the Daisy Avanti Precision Diopter sight, but the dealer I bought from assures me it isn't. Probably made in the same factory but with a different name on it.