I typically use JB Weld....Male certain that the barrel is fully seated.......
I think the only thing that holds the barrel in place is the plastic tab on the bottom of the front sight.
Quote from: Chainsmoker on October 15, 2021, 03:07:23 PMI think the only thing that holds the barrel in place is the plastic tab on the bottom of the front sight.Actually, the barrel is a press fit into the breech.If the barrel had been removed from the breech a few times, that press fit can become a bit loose....If the barrel is not glued into the breech at that point, it can become dislodged inside the barrel shroud.The front sight will not hold it in position..........