All Springer/NP/PCP Air Gun Discussion General > Machine Shop Talk & AG Parts Machining
True up your 3 jaw EASY
KWK:
Get it?
customcutter:
Interesting concept. How did you make the ring, and what material is it?
JuryRigger:
Hmmm.... A bored in-situ 'soft jaw' squeeze ring-do I have it right?
Jesse
rsterne:
I'm pretty sure that only works for the diameter you machine it to.... If the chuck varies as you move the scroll, you will no longer be centered....
Bob
KWK:
--- Quote from: customcutter on September 12, 2022, 11:09:48 PM ---Interesting concept. How did you make the ring, and what material is it?
--- End quote ---
Just a piece of iron pipe was set up on the rotary table. Plunged an endmill 3 places.
--- Quote from: rsterne on September 12, 2022, 11:43:48 PM ---I'm pretty sure that only works for the diameter you machine it to.... If the chuck varies as you move the scroll, you will no longer be centered....
Bob
--- End quote ---
Depends on the accuracy of your scroll. That's why 3 jaws are not your most accurate setup.
This also cures bellmouth or sprung jaws. Will cause serious issues when parting, etc.
Navigation
[0] Message Index
[#] Next page
Go to full version