Great work Mike, really satisfying isn’t it. Imagine what it will do with bullets sorted to specific weights and tethered.I am just tickled your doing that, it will only get better.Regards,Roachcreek
Congratulations, it's a start of a long road but a good start. At the end you'll have very accurate long range airgun that shoots bullets with good BC from magazine. It sounds like the Buldog has many things going for it like the long magazine and possibility to use extra long barrel. I forgot to mention, those 257420 BTs measure 0.18 BC and 257388s should have 0.2 BC. That's about the best bullets we can get up to speed with 3000ish psi.
That's some work to be proud of right there. If you regulated it those groups will likely tighten up even further. Fine job Sir!
Fantastic job so far Mackeral5! Absolutely fantastic! I hope those trigger parts come in, if they haven't already!
Mike,Well done.Roachcreek
You need to get yourself an Aqua Environment tethering regulator. Huma just can't keep up with higher power levels, been there done that bought Aqua Environment. One of these things below but you can get the regulating unit from manufacturer and add the gauges and other pieces and save some money.https://www.bestfittings.co.uk/shop/airgun-charging-equipment/cylinder-accessories/7000-pressure-regulator-kit-for-nitrogen-high-pressure-air/
Quote from: rkr on March 17, 2021, 10:54:15 AMYou need to get yourself an Aqua Environment tethering regulator. Huma just can't keep up with higher power levels, been there done that bought Aqua Environment. One of these things below but you can get the regulating unit from manufacturer and add the gauges and other pieces and save some money.https://www.bestfittings.co.uk/shop/airgun-charging-equipment/cylinder-accessories/7000-pressure-regulator-kit-for-nitrogen-high-pressure-air/Understood. Tethered to a regulated tank and building a regulated gun are 2 different setups.... There is a desire to have a self contained, regulated tube as well as an unregulated tube that can be tethered.I'm good on the tethered setup...
Quote from: mackeral5 on March 17, 2021, 11:36:53 AMQuote from: rkr on March 17, 2021, 10:54:15 AMYou need to get yourself an Aqua Environment tethering regulator. Huma just can't keep up with higher power levels, been there done that bought Aqua Environment. One of these things below but you can get the regulating unit from manufacturer and add the gauges and other pieces and save some money.https://www.bestfittings.co.uk/shop/airgun-charging-equipment/cylinder-accessories/7000-pressure-regulator-kit-for-nitrogen-high-pressure-air/Understood. Tethered to a regulated tank and building a regulated gun are 2 different setups.... There is a desire to have a self contained, regulated tube as well as an unregulated tube that can be tethered.I'm good on the tethered setup...Oh, you got one already. I had HUMA tethering reg and it had trouble keeping up at 150 fpe even when modded according to Huub's instructions. Those internal regs are usually even slower so I don't think there are any neat solutions.
Huub told me to open up some airpaths inside the regulator a bit. Since mine was tethering regulator and yours is internal I would suggest you to contact Huub and ask about flow improvements that you can do, he's a very helpful guy.