Donation

Airguns by Make and Model > Air Arms Airguns

TX200 stock bracket dimensions needed

<< < (2/4) > >>

Frank in Fairfield:
OK.
I will speculate.
The Allen screws were stripped and the owner could not get them out.
In desperation, he yanked the stock off and broke the bracket in two.

One other guess….He tightened the center screw too much.

Happy New Year..

Denby95:
I can get you a measurement in about 3 days but this may have the answers you need.

http://www.airgunbbs.com/showthread.php?638107-TX-barrel-diameter

Roadworthy:
The point at which the stock bracket mounts is about 1.368 inches in diameter which equates to about 34.75 mm.  I have a custom machined bracket on my TX 200.  I'll try to attach a couple of pictures.

Gippeto:
That works. Thank you Thomas. 8)

Al

Frank in Fairfield:
I ordered this one:

Navigation

[0] Message Index

[#] Next page

[*] Previous page