Donation

Airguns by Make and Model > Air Arms Airguns

TX200 stock bracket dimensions needed

<< < (4/4)

Toxylon:
Looking at the pictures Denby provided it looks patently obvious that the very thinnest part of the bracket, with a hole drilled through it, is a weak spot. At the very least, the "floor" should have equal thickness throughout, so a curved top as well as bottom. Then, a countersunk would take care of the screw head leveling.

Frank in Fairfield:
It is always good to have spare.

1. Complete factory rebuild kit.
2. Two sets of breech seals.
3. Two front stock brackets w/stock screws.

The originals will never break, now.. ;D

Frank in Fairfield:

--- Quote from: Frank in Fairfield on January 16, 2024, 08:06:05 PM ---It is always good to have spare.

1. Complete factory rebuild kit.
2. Two sets of breech seals.
3. Two front stock brackets w/stock screws.
4. Two cocking shoes.

The originals will never break, now.. ;D

--- End quote ---

Duckfish:
These?

Navigation

[0] Message Index

[*] Previous page