GatewayToAirGuns.org    Donation

All Springer/NP/PCP Air Gun Discussion General > Machine Shop Talk & AG Parts Machining

Semi retired machinist looking for side jobs.

<< < (11/11)

IOWOLF:
Please, send me a drawing, P.M. or. email.

2A Georgia:
If you fabricate a Hammer spring cover/endplate with the pre-drilled and tapped hole you could sell it as a kit: Challenger Standard to (better than) FX poor man's conversion kit.  I followed that thread but am not as good a machinist as James and shied away from drilling into my endplate...

Back_Roads:
 My busy work season here along with hunting on the way, I will make an attempt to take the H.S. adjuster out and make a detailed drawing ASAP.

IOWOLF:
As it is winter time and don't shoot as much....I am bumping this up.

If You have a project, I would look at it, send me a PM and a drawing.

Navigation

[0] Message Index

[*] Previous page

Go to full version
Powered by SMFPacks Media Embedder
Powered by SMFPacks Alerts Pro Mod
Powered by SMFPacks Ads Manager Mod