Donation

All Springer/NP/PCP Air Gun Discussion General > Show Off Your Air Guns With Mods (SHOW and TELL)

Drop block for Crosman 13XX and 22XX pistols? PCP conversion.

(1/1)

BholdRx:
Does anyone know where I can find a drop block for a Crosman 13XX and 22XX pistol? I am looking for a block that will allow a skinny bottle to fit snug under the barrel, like the store bought air guns using paint ball bottles. I want just the square block. I am going to have a tube made that screws into the aft half of the valve. The block will sit right in front of the trigger.

Back_Roads:
 If he does not have what you have in mind, he may be able to customize one. https://www.froggysairguns.com/

Rick67:

--- Quote from: BholdRx on December 28, 2022, 10:43:02 AM ---Does anyone know where I can find a drop block for a Crosman 13XX and 22XX pistol? I am looking for a block that will allow a skinny bottle to fit snug under the barrel, like the store bought air guns using paint ball bottles. I want just the square block. I am going to have a tube made that screws into the aft half of the valve. The block will sit right in front of the trigger.

--- End quote ---


Try to contact this gent:



https://www.gatewaytoairguns.org/GTA/index.php?topic=186333.0

It looks like they are in semi-finished  state here.


I have several of his 22xx/13xx AR buttstock adapters and they are the best in fit and finish.

Rick67:
Check out this thread:


https://www.gatewaytoairguns.org/GTA/index.php?topic=129415.120


I love the one he did for Killercrow, a fat tube in lieu of a bottle:


https://www.gatewaytoairguns.org/GTA/index.php?topic=129415.140

Gippeto:
Could go either way...finished one for my old QB...past time for a bit of a "do-over". Old stuff on top, new tube and internals below. Spare SSG setup is for a full length balanced valve .25 QB.

Navigation

[0] Message Index