All Springer/NP/PCP Air Gun Discussion General > 3D printing and files
Looking for a CAD/CAM program
Scott_Tx:
I used to use freecad but since then I've switched to openscad which is more like programming instead of using a gui.
customcutter:
Thanks guys, I'll check them out over the next few weeks.
sb327:
I use freecad still because it’s not web based. Kinda clunky but it’s what I know.
Fusion for cam stuff but not needed for 3D printing.
Dave
customcutter:
--- Quote from: sb327 on March 16, 2022, 02:13:36 PM ---I use freecad still because it’s not web based. Kinda clunky but it’s what I know.
Fusion for cam stuff but not needed for 3D printing.
Dave
--- End quote ---
Thanks Dave, I had forgotten about that. With Fusion aren't your files stored in "The Cloud" or what ever the heck that is.... Another reason I was thinking of moving on from Fusion 360.
Rob M:
--- Quote from: customcutter on March 16, 2022, 03:00:41 PM ---
--- Quote from: sb327 on March 16, 2022, 02:13:36 PM ---I use freecad still because it’s not web based. Kinda clunky but it’s what I know.
Fusion for cam stuff but not needed for 3D printing.
Dave
--- End quote ---
Thanks Dave, I had forgotten about that. With Fusion aren't your files stored in "The Cloud" or what ever the heck that is.... Another reason I was thinking of moving on from Fusion 360.
--- End quote ---
yes, its their ransom if someone doesnt pay the bills
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version