Donation

All Springer/NP/PCP Air Gun Discussion General > Show us your Custom Airgun Parts (TRICKS-N-TIPS)

Some frame machining for various purposes.

(1/11) > >>

MJP:
Just thought that I need a alu frame for a gun, now it turned to guns and at least three frames, or four will be made.

One side done.

Mocking the part on Badger just to see if the overall dimensions are sound.
Not ment for this rifle but I think it could end up on it.

Marko

sb327:
Interesting! I bet that made a bunch of chips.

Is it designed for ar furniture?

Dave

Rob M:
nice !!!!!!! lot of  material removal.

MJP:

--- Quote from: sb327 on July 28, 2021, 07:37:23 PM ---Interesting! I bet that made a bunch of chips.

Is it designed for ar furniture?

Dave

--- End quote ---
Yes and no, only ar grip is used, I hate the imperial thread on the buffer tube systems. And to be honest, all the buffer tube furniture looks the same.
Some 35-50L of chips from two frames.

Marko

MJP:

--- Quote from: Rob M on July 28, 2021, 07:59:11 PM ---nice !!!!!!! lot of  material removal.

--- End quote ---

Thanks,
A lot, and alot of time consuming to mill the contours with ball endmill. Roughing amd finishing about 4h per side. I need to optimize the code some if I'm making more of them.

Marko

Navigation

[0] Message Index

[#] Next page