GatewayToAirGuns.org    Donation

All Springer/NP/PCP Air Gun Discussion General > Machine Shop Talk & AG Parts Machining

Theoben stock screw

(1/1)

KWK:
I bought a used Theoben Sirocco Deluxe and found it has a buggered stock screw so I made a new one. I can't stand buggered screws. This one isn't seen. The trigger guard hides it but you know.

KWK:
Set up on my vertical Enco with a slitting saw. I wish I had my little Burke horizontal running but I'm replacing the feed screws so I can't use it now. Finished off with some cold blue. 

happymecanic:
That's very nice work!

I too have a hard time with buggered screws, I fully understand the ''...but you know'' part ;D.

Just keep the cold blued parts well oiled, as they ''catch'' rust easier than hot-salts blued parts ;).

Navigation

[0] Message Index

Go to full version