All Springer/NP/PCP Air Gun Discussion General > UK Airgun Gate
COCKING ARM ON TX200
shep:
just to make sure,on my TX there is also an adjustment to keep the cocking lever tight...from flopping down.
Hoppalong Doc:
I'd sure like to know where exactly that adjustment is located. Mine's fine for now, but for next time , . . ? Orv.
WildCJ5:
At the muzzle end of the arm where it pops into the detent. That end part is threaded on and lock tight from factory. I had mine come loose. If it does just remove it, clean up and reapply some new thread lock.
Hoppalong Doc:
That was my bad . . . I was reading the linking arm having a way to adjust it. My arm itself is tight against the barrel, at least for now. Thanks for the add, Orv.
Navigation
[0] Message Index
[*] Previous page
Go to full version