Donation

Support Equipment For PCP/HPA/CO2 and springers ,rams > 3D printing and files

Buck Rail's new modular moderator

<< < (2/2)

subscriber:
Both ideas combined to achieve a slop-less thread fit, that is also smooth.   Thanks


--- Quote from: OldCrow on August 22, 2024, 11:56:27 AM ---
--- Quote from: WobblyHand on August 12, 2024, 07:02:51 PM ---
--- Quote from: subscriber on August 11, 2024, 11:05:25 PM ---Do the thread below look "shallow", as if they have a 90 degree included angle, rather than 60?  That would make them easier to print smoothly, and should work well, if the threads are coarse enough.  Perhaps I should try it :)



--- End quote ---
I've printed 32 TPI 60 degree threads in PETG without much issue.  But my trick on assembly is to use silicone oil on the threads.  Then it screws right on.

--- End quote ---

 I do the same thing and I heat the plastic gently to about 140-180f with a lighter before engaging the threads.  This also helps to get a good tight fit.

--- End quote ---

Navigation

[0] Message Index

[*] Previous page