I tried to post a pic, but no bueno, and I'm on my phone, so maybe tomorrow.
...Be sure to try some H&N FTT pellets. Mine loves them!
...(Without a chrony, it dint happen)
My 140 was the first pumper I ever fixed. Good one to start on.
...did you replace the pump cup?
GREAT ! The 1400 is a good shootin little rifle.
Quote from: Mackado on October 24, 2018, 04:17:45 AM...did you replace the pump cup?Yes, I did. The one extra thing that I had to do beyond what Rick recommended was to heat the brass retaining ring with a heat gun.Basically, Rick said to cut off as much of the old cup as possible and grab the piston/ rod assy in a vice by the piston. (Protecting it, of course)Grab the brass retainer with regular pliers and wedge a screwdriver between the pliers and the vice and work it off. File off any minor damage to the brass ring.Mine was stuck a bit harder than this, and I had to heat and get it broken loose by spinning it first.The worst part was getting the q-seal to lay down right- toothpicks and several attempts were required, but no biggie there either really.
... I tried different ways already and it didn't work at all.