GTA

All Springer/NP/PCP Air Gun Discussion General => PCP/CO2/HPA Air Gun Gates "The Darkside" => Topic started by: Charles Outdoors on April 15, 2012, 02:38:23 PM

Title: Hatsan PCP rifles - How many useable shots per fill?
Post by: Charles Outdoors on April 15, 2012, 02:38:23 PM
Looking at the Hatsan specs they claim 60-70 shots per fill on most their rifles and Hatsan don't normally fudge numbers. The BT65 RB for example claims 1070 fps in .25 cal. with 65 shots at 200 bar.  I know there is a power curve, but how many usable shots do they get?
Title: Re: Hatsan PCP rifles - How many useable shots per fill?
Post by: Ribbonstone on April 15, 2012, 03:12:56 PM
Define "useable".

IF you count how many shots that manage to dribble out the barrel in the general direction of the target, then it is probably much more than 70 shots.

If you count only the number of shots that are within 3% (or a more liberal 4%) of max. velocity, then it will be a whole lot less than 70  shots (and they do not advertise 70 shots for the .25 versions...forget the number, but its less than 70).

There is some adjustment built into the system (is kind of hidden and hot really adjustable unless taken out of the stock, but there is a spring tension adjustment).  How low you have it adjusted to shoot changes the shot count as well, but lets consider the expected real-world numbers from an out-the-box Hatsan PCP.

Will use this calculator for estimates:
http://calc.sikes.us/1/index.php (http://calc.sikes.us/1/index.php)

IF you plug in 3000 start fill and 1900 as the end pressure (a pretty liberal pressure range)
180cc as the volume (although they make long tubed versions as well as the standard 180cc tubes)-
use 26gr. as a "average" .25 pellet and use 850fps as the velocity.

Can keep plugging numbers for the shot count into the equation until you get a bar-cc/fpe efficiency rating of about 11 (which is a pretty good efficiency).

Doing that, come up with 28-30 shots.  From past experience, that would probably be the best real-world shot count within a reasonable velocity variation (meaning a variation low enough that you wouldn't notice the shift in vertical at short ranges like 25yards).

.177 Example: a simple Pneuma, but from what I can tell, all the PCPs use the same valve system so it could be useful to other models.  Has been farted around with and adjusted, but running on stock parts.

(http://i157.photobucket.com/albums/t50/ribbonstone/pneuma/DSCF1273.jpg)

IF you keep to 4% of max, then could count 60 shots inside of 4%'
IF you keep to the 3% max, then about 48-50 shots.

NOTHING adds to shot count like OVER FILLING.  Once you get close to valve lock, it takes an amazing number of shots to bleed off enough air to let the gun get back up to normal speeds.  Once overfilled this gun by 35 BAR (not over MAX pressure, just over the pressure it had been set to run at) and it took me 60 shots before it got to the expected curve...while they were not "useful" shots in that they shot way-way low, could count them as "shots" and claim 150-175 shots per fill for the same gun as above.


Title: Re: Hatsan PCP rifles - How many useable shots per fill?
Post by: rsterne on April 15, 2012, 10:46:32 PM
I had a stock .22 cal Hatsan AT-44 and for 30 shots (3 clips) the total velocity spread was 6-7% depending on pellet weight.... Within a 4% window, it got 23-26 shots between 26-33 FPE depending on pellet weight, with the heavier pellets producing more energy and more shots.... That worked out to an efficiency of 0.93 - 1.20 FPE/CI, with the heavier pellets being more efficient....

I know of a modded BT-65 in Canada shooting about 70 FPE with EunJin 43 gr. points.... but I think the shot count is about one 9-shot clip at that power.... I don't know what the "good" shot count is for a stock .25 cal.... but the BT-65 has a larger reservoir than the AT-44.... It should, it's a couple of lbs. heavier, at about 9 lbs. without scope....

Bob