I believe that the O/P wants to raise the breech up from the tube, not a sight issue.
Anyone know where I could get a breech riser? 3d would work as I can't find anything under $50 and I just don't feel like it should cost that much.
What size pvc pipe would work? I could get that easier lol
This is made the same as the other one above from 1/8" wall thickness PVC pipe but I left it a little long for this short breech in case I want to change to a long breech. It's a 7/8" TKO in .25cal. I like my carbines better than full length Discos for hunting and pesting. They are quick to pump up to 2500psi with Magnum valve screws and still get enough shots for pesting and I hate a moderator hanging off the front of the tube, so I always cut the barrel back and crown to make them flush with the tube.
Quote from: Van on April 19, 2023, 10:08:31 AM This is made the same as the other one above from 1/8" wall thickness PVC pipe but I left it a little long for this short breech in case I want to change to a long breech. It's a 7/8" TKO in .25cal. I like my carbines better than full length Discos for hunting and pesting. They are quick to pump up to 2500psi with Magnum valve screws and still get enough shots for pesting and I hate a moderator hanging off the front of the tube, so I always cut the barrel back and crown to make them flush with the tube. That's a sweet looking carbine!
You mean something like GMAC sells? I have one and its a nice piece of work. https://gmaccustomparts.com/multi-shot-breech-37
Quote from: JayDee24ca on April 19, 2023, 02:05:19 AMYou mean something like GMAC sells? I have one and its a nice piece of work. https://gmaccustomparts.com/multi-shot-breech-37Looks like a nice piece of kit, but too rich for me!