you could dill out the end of your cast bullets untill you get the right weight
This is a thin walled 357 hp that expands well at 700 fps.
Quote from: EdinGa on January 20, 2021, 06:23:47 PMThis is a thin walled 357 hp that expands well at 700 fps.Cool looking "special" load. Is that powder coated? What alloy are you using?
Looks to me like you are trying to get the walls of the nose too thin, and having problems with lead flow.... I would suggest that you put a straight taper on the HP pin, instead of the convex curve you have now.... You will end up a bit heavier, but with much improved lead flow into the front edge of the nose, I think....Bob
I modded a Lee .45 mold a while ago, weight dropped from 220 gr down to 180 gr:hp-mold2 by abbababbaccc, on Flickr