GTA
All Springer/NP/PCP Air Gun Discussion General => PCP/CO2/HPA Air Gun Gates "The Darkside" => Support Equipment For PCP/HPA/CO2 => Topic started by: AirgunErik on January 14, 2022, 05:00:09 PM
-
Hi all.
I have a Air Venturi Fill Assembly Hose with a 1/8 bspp female connector. I ordered a foster connector to attach. It came with a delrin donut which I had never seen before. I was going to use thread tape to put these together but would like to know if I should use the donut. It doesn’t seem to allow for as solid a connection as thread tape would.
I’d like any advice from the experts. Thanks.
-
Use the delrin piece.
It will seal better
-
Thanks
-
BSPP seals on the delrin seal, not the threads as a NPT does.
-
Thanks! I appreciate learning something new!