Looks great! I see you have one of the new style Exclusive breechs. I noticed in your parts list the Hill Depinger. Were you getting ping? Typically, using a reg will eliminate ping, but haven't done any shooting yet with my BROD project, to know if that large of plenum can create ping or not. Assuming it i installed up against the valve, I'd be concerned that it may also be a bottleneck
Quote from: FuzzyGrub on August 25, 2020, 04:16:12 PMLooks great! I see you have one of the new style Exclusive breechs. I noticed in your parts list the Hill Depinger. Were you getting ping? Typically, using a reg will eliminate ping, but haven't done any shooting yet with my BROD project, to know if that large of plenum can create ping or not. Assuming it i installed up against the valve, I'd be concerned that it may also be a bottleneckI decided to use one based on my experience with my bottled prod. When I lowered the reg setting I did notice the annoying ping. Rather then test my luck I just decided to use one in this build from the get go.
It looks like the exclusive breech doesn't have enough clearance for a 3/8 OD hole. I think I will be limited to 5/16 OD, so this will allow for .234 ID transfer port.
Yup exactly. It looks too close for comfort, especially with a hand drill.A 3/8 hole would allow me to use .25ID transfer port.
Appreciate that. I don't have an OEM breech to compare. In fact, the only OEM part on this build is the trigger assembly.
Quote from: Jzizzle on August 28, 2020, 10:43:03 AMAppreciate that. I don't have an OEM breech to compare. In fact, the only OEM part on this build is the trigger assembly.As I thought about it, it would need to be the same as the mrod breech or extremely close. The barrel and TP postion has to be the same, along with the width of the mag well. Still, how to get some input from someone that has already done it. I' hate to skrew up and trash it.