Dropped my Career II 707 on its tip and bent it....Does anyone know who can repair it?
Quote from: pepegraves on August 31, 2022, 12:59:23 PMDropped my Career II 707 on its tip and bent it....Does anyone know who can repair it?I'm sure we can find somebody here who can; if you need measurements for "factory barrel" Career 707 in 9mm, holler- yeah, I'm talking "upgrade" the barrel
I can't believe I posted that 2x's ....GEEZ!....thanks for the answers, video....I thought in the meantime I might try n do it myself...this is how far I got I cannot get the barrel out at this point....Ima watch the video...thanks again....Well, that's the video I watched this morning....I was trying to avoid some of it being that all I wanted was the barrel off ...Tell the truth I'd just rather pay someone that's smarter than me, with a good track record to do it....any suggestions would be appreciated
Quote from: pepegraves on September 05, 2022, 02:45:06 PMI can't believe I posted that 2x's ....GEEZ!....thanks for the answers, video....I thought in the meantime I might try n do it myself...this is how far I got I cannot get the barrel out at this point....Ima watch the video...thanks again....Well, that's the video I watched this morning....I was trying to avoid some of it being that all I wanted was the barrel off ...Tell the truth I'd just rather pay someone that's smarter than me, with a good track record to do it....any suggestions would be appreciatedGetting the barrel out requires disassembly of the reciever. It's not very hard and you've done most of the hard part.
The assembly hard part is getting the transfer port aligned while getting it back into the reciever. I used black electrical tape to hold it together while I slipped it back into the receiver. Then all you have to do is slip the barrel and pressure tube band back on being careful to not Knick one of the Orings.