Donation

All Springer/NP/PCP Air Gun Discussion General > Big Bore AirGun Gate

Serpent Arms Air Guns 550L 28ga Shotgun Experience

<< < (2/9) > >>

DLP:
That not worthy! Sending it back or doing the repair yourself if it’s possible?

Back_Roads:

--- Quote from: DLP on December 07, 2024, 09:12:53 PM ---That not worthy! Sending it back or doing the repair yourself if it’s possible?

--- End quote ---
Contacted them to repair the bottle valve setup, I figure it could save them future issues if they find a cure for the cause.

BadFishHagDog:
How does the machining on the internal components look? That Serpent Arms spun off from a US machinist is appealing to me and would lead me to expect pristine finishes on all components. Hard to tell that level of detail in photos, but some of those components look less than perfect?

These appear, externally anyway, to be a functionally identical copy of the Evanix REX series. Does anyone know if this is correct?

I have come across a couple of claims of excessively heavy trigger pull, and from the couple of videos I can find they seem to make a rather harsh "clang" on firing. I'm curious to see if Serpent Arms will become the next Airforce, or fade into airgun history. I see a lot of potential here if they make these well and listen to early users input.

Thank you James.

Jared

Back_Roads:
 Machining is as good as Airforce I tend to want to compare to. Cocking is stout, and the one pull I did on the trigger reminded me of my crossbow triggers. Not a backyard plinking gun ;)

Back_Roads:
 I re watched the Airgun Channels review, the trigger pull is just under 3 1/2 pounds. I will be sending the bottle in on Monday for repair at their cost. Good customer service I got a reply late Saturday afternoon.

Navigation

[0] Message Index

[#] Next page

[*] Previous page