Donation

All Springer/NP/PCP Air Gun Discussion General > 3D printing and files

Daisy Powerline 426 suppressor silencer .stl file for 3d printing

<< < (2/26) > >>

subscriber:
Baffles?  Absolutely, yes.  I said "tube" as a euphemism for the device.  It may be that I am making communication difficult by being too clever for my own good; because your English seems excellent.

That sectioned design has a "spigot" interface to the barrel.  I don't know if there is room for that on the 426.  I suspect that we could get away without that, but the more detail you provide, with measurements, the more intricate design can be made - and actually fit.

Mel:
Ok thanks so much for your help. I'll take measurements and post them asap.

subscriber:
So, I assumed a 4" length and a 1" width across flats for the 426 Moderator.  Before long I arrived at the design shown below.  Yes, it has no rail adaptor interface yet, so the lower curved aspect might need to shift up or down relative to the bore.  Yes, the design images posted above may have influenced me, despite saying that a rectangle would be harder to do properly.

What is the width of the pistol, across the flats?  I will make the mod width match that.

What about obscuring the front sight?  Do you want clearance for that; or a "sighting trough"?  Or a replacement print sight integral with the moderator?

Mel:
Here are the measurements
It should look like this

subscriber:
Thanks, Mel

There is a lot to digest there.

Navigation

[0] Message Index

[#] Next page

[*] Previous page