Donation

All Springer/NP/PCP Air Gun Discussion General > 3D printing and files

Daisy Powerline 426 suppressor silencer .stl file for 3d printing

<< < (26/26)

Mel:
Good morning!
I managed to print v6 silencer in one piece in 10cm3 printer, just 4 fun.
I reduced z axis only, from 133 to 124mm and then leaned it.
I share stl.
I also cut 2.5mm at the bottom for better adhesion and printed without supports, but meshmixer add some ugly lines at the bottom face no matter whatever i try.
Thanks subscriber!

subscriber:
Mel, your print quality has improved.  Experimentation is good for learning new things and increased understanding.

Mel:
Thanks for your kind words subscriber!

subscriber:
I guess there are bits of that part that don't look as good as the rest.  The question is why?  My guess is the unsupported overhang is too much.

Mel:
Hi again!
i managed to avoid the ugly lines when cutting 2.5mm botton  thanks to prusaslicer cut function
i attach pics and .stl with mentioned cut for better adhesion when printing v6 one-piece in 10cm3 printer
im waiting for self-lubricated 6x8x10mm bearings for carriages for new printer i bought for a present.


--- Quote from: subscriber on November 21, 2024, 04:13:40 AM ---I guess there are bits of that part that don't look as good as the rest.  The question is why?  My guess is the unsupported overhang is too much.

--- End quote ---
Yes, i printed unsupported just for fun and see what errors would appear.

Navigation

[0] Message Index

[*] Previous page