GatewayToAirGuns.org    Donation

All Springer/NP/PCP Air Gun Discussion General > German AirGun Gate

House fire diana 48 resurrection!!!

<< < (3/6) > >>

Roadworthy:
I used a C clamp as the basis for my spring compressor.  I've attached a bit of additional info.  I do recommend the use of dummy pins when disassembling a T01 gun.  Do NOT put pressure on the safety!!  I used about a one inch square of 3/4" wood and drilled a half inch hold through it.  I slip the safety through the hole, it will not extend clear through.  I then apply pressure to the wood.

Madd Hatter:
Just a note. If your rifle is a to1 do not buy the vortex kit as it won't all fit. The ARH offers a specifically for the to1. You can install the vortex kit but have to leave the top hat out.

SwampHunter:
Thank you Thomas,  I will try and replicate that and make sure I have the extra peice with the hole in the safety.  Thank you Robert , I believe that I will be going with the ARH kit.

Bad News Beeman:
How much did you buy this rifle for OP?

If the cost of parts run you over $200, I'd say go for a used gun unless this is labor of love kind of project (which is totally understandable if so).

SwampHunter:

--- Quote from: Bad News Beeman on September 17, 2023, 03:12:27 PM ---How much did you buy this rifle for OP?

If the cost of parts run you over $200, I'd say go for a used gun unless this is labor of love kind of project (which is totally understandable if so).

--- End quote ---
It probably will, but that will be ok, hopefully it will be worth it, if it shoots like I want. I can always fill the stock with wood putty and paint it to save money. Then basically all I have money in is a tune kit which I have been wanting to try anyway, I have always been nervous to tear into one. This t01 trigger is making me nervous now, everyone makes out like it is a big deal to take one out. But, only way to find out if I can do it is to try

Navigation

[0] Message Index

[#] Next page

[*] Previous page

Go to full version
Powered by SMFPacks Media Embedder
Powered by SMFPacks Alerts Pro Mod
Powered by SMFPacks Ads Manager Mod