Donation

All Springer/NP/PCP Air Gun Discussion General > 3D printing and files

Big Delta in the house

(1/3) > >>

oldpro:
 Running test prints and so far super impressed

oldpro:
 WOW this thing is fast!!!! and quiet. The Robo might not see much time if this thing doesnt break.

PCPhack:
Yes, they are great.  ;D

Did you get the -s 32 bit one and the level sensor too?

AGEnthused2:
The flsun printers are nice, I’ve had trouble with mine, but figured out enough to get it printing well.
Chinese New Year followed by COVID-19 basically meant I had no customer support.
Anyway have fun playing around with the printer, you may have to reinstall the firmware a few times if you adjust the Z height wrong.
I printed for 54 hours non stop with mine a few weeks ago, printing went well after a lengthy setup.

oldpro:

--- Quote from: PCPhack on May 13, 2020, 12:56:44 AM ---Yes, they are great.  ;D

Did you get the -s 32 bit one and the level sensor too?

--- End quote ---
I did! It went so smooth from set up to print. I never had any other printer go from box to awesome so fast. I’ll post some prints shortly

Navigation

[0] Message Index

[#] Next page