A little update on this sight mount solution. I notice that there is a tendency for the optics and the mount to twist around ever so slightly on the barrel if the hex screws aren't torqued down tightly. Be aware of this, as this will impact the POI significantly if your 1377 is being banged around constantly.If I were a serious shooter, this mounting solution would be a no-go. It's not stable enough for my liking. As a plinker, I'll deal with it.Turby
I wonder if the bottom part of those mounts could be extended to fit around the pump tube to prevent that?
Quote from: Underdog on September 16, 2022, 05:15:20 PMI wonder if the bottom part of those mounts could be extended to fit around the pump tube to prevent that?Maybe -- what would one do -- weld to it? I guess if one could do it such that the mounts still line up ok, that would work.Turby
Washers could be installed in between to eliminate slop.
No idea about the existing one. But I was thinking that maybe someone made some similar scope mounts that wrapped around the pump tube? I know there are a couple different ones. Someone with a 3D printer could mock some up fairly quickly...
Quote from: Turbinator on September 16, 2022, 06:55:54 PMQuote from: Underdog on September 16, 2022, 05:15:20 PMI wonder if the bottom part of those mounts could be extended to fit around the pump tube to prevent that?Maybe -- what would one do -- weld to it? I guess if one could do it such that the mounts still line up ok, that would work.TurbyNo idea about the existing one. But I was thinking that maybe someone made some similar scope mounts that wrapped around the pump tube? I know there are a couple different ones. Someone with a 3D printer could mock some up fairly quickly...