Quote from: Craymar on April 25, 2015, 01:09:24 AMQuote from: Craymar on April 23, 2015, 06:07:58 PMThe X50 is a variant of an RWS 350 clone from my research. Based off of a BAM B28 if I remember right. Did a bit more digging and found that the X-50 is actually a BAM B22, Same as the Benji Superstreak. http://www.gatewaytoairguns.org/GTA/index.php?topic=36161.0So then that validates what I was asking earlier about it since its the same as a Super Streak. Interesting.
Quote from: Craymar on April 23, 2015, 06:07:58 PMThe X50 is a variant of an RWS 350 clone from my research. Based off of a BAM B28 if I remember right. Did a bit more digging and found that the X-50 is actually a BAM B22, Same as the Benji Superstreak. http://www.gatewaytoairguns.org/GTA/index.php?topic=36161.0
The X50 is a variant of an RWS 350 clone from my research. Based off of a BAM B28 if I remember right.
Quote from: LAalex on April 23, 2015, 03:36:38 PMThe chart in this post might give you some good comparisons. The X50 IIRC is an iteration of the old Super Streak. Now, if they have built an entirely new tube that changes the equation. There is a relatively simple formula to determine swept volume and also some calculators where you just plug in your measurements.http://www.gatewaytoairguns.org/GTA/index.php?topic=24542.0ScottyAs I understand it, the Hat 125 barrel is about 2" longer than the 135, hence the larger swept volume of the 135 is needed to maintain equal FPS to the 125.
The chart in this post might give you some good comparisons. The X50 IIRC is an iteration of the old Super Streak. Now, if they have built an entirely new tube that changes the equation. There is a relatively simple formula to determine swept volume and also some calculators where you just plug in your measurements.http://www.gatewaytoairguns.org/GTA/index.php?topic=24542.0Scotty
John isn't the Hatsan Vortex a gas piston? I am asking because of your comment of putting tar on the spring. I have the Striker 1000s .25 in spring version and when I fire the spring is so Loud it sounds like something breaks! I have a new seal, chromoly paste, tar, and was getting up the ambition to try and disassemble it. I am getting 630 fps or so with h the FTT 19 grain domes. Did your lube tune give you that much more in power?