how do i go about changing that pice?please explaine.
Here's an exploded view of the M10, maybe it will help people that aren't familiar with the insides of the gun.I enhanced it from the Mrodair pic to make it a little easier to see.
So i just finished fixing the M10 air leak from the intake valve took the valve off and took out the screw in the middle sprayed some cleaning lubricant put the fill probe and pumped it so if there was something in there it would get blown out Put it back on the rifle pumped 10mpa and no leaks holding air once again Gina leave it there till tomorrow and see if it will hold the air
Quote from: eezapz2101 on March 31, 2017, 05:49:40 PMSo i just finished fixing the M10 air leak from the intake valve took the valve off and took out the screw in the middle sprayed some cleaning lubricant put the fill probe and pumped it so if there was something in there it would get blown out Put it back on the rifle pumped 10mpa and no leaks holding air once again Gina leave it there till tomorrow and see if it will hold the airBe careful what you're spraying around in there. If you introduce petroleum-based fluids into your compressed air cylinder, you could blow your gun up. In the same way that diesel fuel ignites under intense pressure, some petroleum products will ignite in a PCP.
How does the transfer port remove? While I had mine disassembled to clean, I tried to remove the transfer port to check the barrel loading cone area and possibly smooth the edge of the transfer port hole but couldn't easily remove it so I left it in place. Seems it should come out away from the barrel if the loading port is out but mine wouldn't budge.
Hi all, has anyone found a source for SPA M10 parts other than MrodAir? The valve on my M10 has leaked since coming out of the box and it is getting worse, will no longer hold air, leaks steadily. I looked for trash in the valve body but can't see anything and valve parts look fine, so I think the valve body has a defect and won't seal.
I read somewhere that just installing a reg kills ping, but I have no personal experience with this.
Mine has a pretty harsh ping as well. I'll put one of those brushes in when the Huma regulator arrives and can be installed or does the regulator quiet the ping enough by itself? Anyone have any idea?